| |
| Ready to Go
Pre Spaced |
| We care that
your finished Do-It-Yourself sign is professional.
Get in touch
with the team to help
Pre spaced, with our unique
lift tape, you can easily install your own signs and
signwriting perfectly.
Our sign makers will send to you
your lettering Ready to Go. You will also receive
installation instructions and a Proof Copy with
measurements. Easy.
Not confident, No problems. Oops... a few bubbles.
Any bubbles are easy to fix. Simply use a pin to prick and
allow the air to be removed. All vinyl self adhesive
lettering takes approx 3 weeks to fully mature, so bubbles
will disappear.
Buy our optional Application Kit:
Includes a plastic squeegee for smoothing out and pressing
down your vinyl lettering, a sharp Knife with extra blades
and a fine mist spray bottle for adding a touch of control
and re-positioning if required.
|
 |
Four Easy Steps
to apply your new
Do-It-Yourself Vinyl Letters
| Format: |
5-7 year Vinyl lettering. Suitable for
boats, vehicles, sign boards and General Signage. |
| 1 |
1. CLEAN AND DE-GREASE your signage surface. |
| |
The lettering supplied will match the
proof supplied to you perfectly. Each line of lettering will
have a pencil mark showing you the centre point, left or right
point for your reference. This will make it easy to align multi
lines of lettering / text / logo etc. |
| 2 |
MEASURE the position of the line from either
the top or the bottom of the sign, the section on the vehicle,
banner etc.
|
| 3 |
TURN THE LETTERING OVER, showing the back
side of the silicone paper, this will make removing the line
easier for you. Put the lettering onto your line by peeling back
the silicone backing. This will leave the lettering upside down.
Using a Household spray bottle, apply a light mist over the
lettering.
The lettering is sticky. Applying a light mist over the adhesive
will allow you to re-position any necessary movement. Hold the
line at each end, turn over and place onto your pencil marked
line.
WHEN IN POSITION APPLY PRESSURE TO THE LETTERING USING OUR PLASTIC
APPLICATOR KIT, CREDIT CARD OR OTHER FLAT SQUEEGEE TOOL, WORKING
FROM THE CENTRE, UP AND DOWN, SQUEEZING OUT ANY
AIR OR WATER.
|
| 4 |
RUB THE LETTERING ONTO THE SIGN. Once you
have pressured the lettering onto the sign, remove the top
covering tape from left to right at a slight angle, LEAVING THE
LETTERING BEHIND IN PERFECT POSITION.
|
Want to see how we make an
AFrame sign in Australia using
our DIY Lettering? Go HERE >
Free Call
Australia 1800 815 166 |
| |
|
|
